A simple laundry routine starts with measuring. Here’s how to use All Natural Laundry Soap for a wash load and prepare the pretreat paste described on its product page.
Measure for your wash load
- Extra-small to small loads: use 1 tablespoon of laundry soap.
- Larger loads: use 2 tablespoons.
Use a tablespoon measure rather than guessing. Follow your washing machine’s instructions for adding detergent and your garment’s care label for washing settings.
Dilution and pretreatment: make a paste
The product page describes a paste, not a liquid detergent dilution: add a little water to 1 tablespoon of detergent. It does not specify an exact water-to-soap ratio or a treatment time.
- Check the garment’s care label before attempting a spot treatment. If it calls for professional cleaning, seek guidance from your cleaner instead.
- Measure 1 tablespoon of laundry soap into a small container.
- Add a little water at a time and mix to form a paste. This is a preparation amount, not a direction to apply the whole tablespoon to one stain.
- Before treating the visible stain, test a small amount on an inconspicuous area. Stop if you notice an unwanted change.
- If the care instructions permit spot treatment and the test is satisfactory, apply a small amount of paste to the stained area, then wash according to the garment’s care label and the product’s wash-load directions above.
No soak or leave-on time is provided on the product page, so don’t assume an extended treatment is appropriate. Keep this preparation to soap and water rather than adding other cleaning products. Results can vary by stain and fabric; pretreatment is not a guarantee of stain removal or fabric compatibility.
Expect fewer suds
All Natural Laundry Soap is described as a low-sudsing detergent. A lack of visible suds is not a reason to add more than the recommended amount.
Ready to measure your next load? Shop All Natural Laundry Soap and review the product directions.